Precautions For Proper Use; Part Description - Panasonic HG-F1 Series Manual

PRECAUTIONS FOR PROPER USE

• This catalog is a guide to select a suitable product. Be
sure to read instruction manual attached to the product
prior to its use.
• Never use this product as a sensing device
for personnel protection.
• In case of using sensing devices for
personnel protection, use products which
meet laws and standards, such as OSHA,
ANSI or IEC etc., for personnel protection
applicable in each region or country.
• If the product is controlled or adjusted using
a procedure other than the one specified
in the instruction manual or user's manual,
exposure to the hazardous laser radiation
may result.

Part description

Beam emitting part
(laser opening)
Beam
receiving part
Emitted beam spot check method
• The emitted beam spot check mode is available to facilitate the confirmation of the laser beam spot position. When this
mode is used, the beam spot becomes brighter and flashes.
Activate the emitted beam spot check mode by following the procedure described below and adjust the workpiece position.
① After turning ON the power, make sure that the display
shows the following measurement screen. Then, press
and hold the UP key for 3 seconds or longer.
The emitted beam spot check mode will be activated.
< Measurement screen >
Hold down for 3 seconds.
• When the "emitted beam spot check mode" is used, sensing objects cannot be measured.
• By holding down the UP key for 3 seconds or longer while the "emitted beam spot check mode" is selected, you can
return to the measurement display.
• The display automatically returns to the measurement display when 2 minutes elapse after the sensor is set to the "emitted
beam spot check mode". To continue to adjust the beam axis, hold down the UP key for 3 seconds or longer again to set
the "emitted beam spot check mode".
Refer to the instruction manual for details. The instruction manual can be downloaded from our website.
Operation /
display section
④Teaching indicator (Yellow)
⑤Output operation indicator
Mounting
⑥Laser radiation indicator
hole
No.
Emitted beam spot
check mode screen
• This product is classified as a Class-1
laser product under the IEC / JIS / GB / KS
standards and FDA regulations*.
Do not look at the laser beam through an
optical observation system such as a lens
since doing so is very dangerous.
• The following label is affixed on the side of
the product as per the safety regulation for
laser products.
* This product complies with the FDA regulations (FDA 21 CFR 1040.10 and
1040.11) in accordance with Laser Notice No. 56 of the FDA regulations,
except for the conformity with IEC 60825-1 Ed. 3.
③Zero set indicator (Yellow)
(Orange)
(Green)
TEACH key UP key
Name
①
Digital display (Red)
②
PRO indicator (Yellow)
③
Zero set indicator (Yellow)
④
Teaching indicator (Yellow)
Output operation indicator
⑤
(Orange)
Laser radiation indicator
⑥
(Green)
② The product emits a spot beam in 1-second intervals.
While observing the beam spot, move the sensor unit and
adjust the optical axis.
②PRO indicator (Yellow)
①Digital display (Red)
DOWN key
Function
Displays measured values and settings.
Lit when PRO mode is set.
Lit while the zero set function is ON.
Lit while teaching is in progress
Lit while control output is ON.
Lit while laser beams are being emitted.
Spot beam
Panasonic Industry Co., Ltd. 11