Table of Contents
Advertisement
TOUCH SCREEN PANEL
Panoramic - Injection + Absorption
1
2
3
4
5
6
8
9
15
1.
Menu Overview: if pressed, you pass to the mail screen.
2.
Menu Process Data: if pressed, you pass to the page of data process index.
3.
Menu Alarms: if pressed, you pass to the list of current alarms, their history and thresholds' settings.
4.
Menu Conf. Backup (level access administrator): if pressed, you pass to the screen of download/upload of the system
configuration data
5.
Menu Configuration (minimum level access administrator): if pressed, you pass to the page of general HMI settings related to
the display and the configuration parameter of the serial lines.
6.
Numeric display of gas flowrate (Smc/h).
7.
Numeric display of residual level inside the tank (l).
8.
Numeric display of the odorant set point (mg/Smc) – input enable with user access Administrator.
9.
Numeric display of the current concentration (mg/Smc).
10. Operation mode of the system:
• Background color red = injection not active (FAIL/STANDBY)
• Background color green = injection active (RUN)
11. Operation mode of the emergency system:
• Background color red = absorption not active
• Background color green = absorption active
12. Button of injection activation/deactivation (access level Operator):
• Color green: injection active
• Color red: injection not active. System in emergency (absorption active or injection active by a slave)
13. Numeric display of the analog signal of "Spare 1" (settable only by user Manufacturer and visible if present).
14. Numeric display of the analog signal of "Spare 2" (settable only by user Manufacturer and visible if present).
15. Login/Logout.
16. Visible if Master/Slave Configuration is enabled
• A DO200 A - B DO200 B - Master DO200 Master - Slave DO200 Slave
The Eng. Unit of the gas flowrate are settable under Administrator access, depending on whether it is Smc or Nmc. At the top of
the screen, on the right, is shown the timestamp of the system synchronized with the PLC one. At the bottom:
• Username access to the parameters (or pages) locked
• Software version loaded
The Touch Screen has the function of "screen-saver" and energy saving that, in case of inactivity, goes in standby and switches off.
In order to active it, just press anywhere on the display surface.
16
10
Dosaodor DO200
11
12
7
Visible if
13
present
Visible if
14
present
23
Advertisement
Table of Contents
