Table of Contents
Advertisement
The curing process in the Zortrax Curing Station involves using synthetic resin which in a liquid
form is toxic and may cause allergic reactions. Therefore, you must protect your skin and eyes
when using the device by wearing safety gloves and glasses. Provide proper ventilation on site
while the machine is in operation.
It is also extremely important to avoid spilling the cleaning solvent on the device and its
surroundings. Ensure that the device is leveled and placed on a stable surface. Do not open
the device during the curing process.
Do not leave the machine unattended during the curing process - check it periodically for
proper functioning in order to avoid potential accidents or breakdowns. Do not ignore
warnings and notifications displayed on the screen.
Monitor your device for wear and tear regularly. Contact our Support Center via the support
form at:
https://support.zortrax.com/support-form/
for assistance when necessary.
Keep the device away from heat sources, flammable materials, equipment emitting radiation,
sources of fire, humidity, water and other liquids. To prevent any inadvertent use, keep the
device out of reach of children and animals. It is forbidden to drop or shake the device as
it may cause breakdowns. The equipment is not intended for use in a potentially explosive
environment.
The Manufacturer strongly recommends setting up a special room dedicated only to 3D
printing and post-processing. The room should be as free of daylight as possible and properly
ventilated. It is important to avoid situations in which liquid resin is exposed to daylight.
Workplace Health and Safety
All service and maintenance activities as well as device operation and maintenance require
using safety gloves and glasses included in the Starter Kit. It is also advisable to wear protective
clothing.
Keep the workplace clean. Containers with resin should be tightly closed and kept in a dark
place.
The device should be configured according to its intended purpose. Improper configuration
may cause defective operation which may lead to damage of the device.
Food and beverages should be kept away from both the device and the 3D printed objects. Do
not put any objects inside the device.
©2022, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
4
document are registered trademarks of Zortrax and are subject to legal protection.
Advertisement
Table of Contents
