Navigating through the Menu
Start Curing - this option allows you to start the curing procedure. First, you have to set
the curing time.
Settings:
Curing Power - this option allows you to set the curing power in the range of
10 to 100%,
Rotation Speed - this option allows you to set the rotation speed of the glass
table in the range of 10 to 100%,
Buzzer Settings - this option allows you to change the Button Click Sounds
(Disabled/Enabled) and the Procedure End Sound (Disabled/Single beep/Melody),
Language - this option allows you to change the language of the menu,
Standby Time - this option allows you to set the time after which the device
goes into the sleep mode.
Device Info - this tab contains information which identifies the device model, its firmware
and hardware version, serial number, and total curing time.
©2022, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection.
15