Table of Contents
Advertisement
3. Remove the model from the platform by hand or use a spatula. If you have problems with removing the
print, use a cutting knife. Remove the raft and support structures from your model.
4. Put the model in the Curing Station or in any source of UV light (e.g. direct sunlight).*
*Depending on the type of resin you've used for printing, this step is optional.
©2022, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
17
document are registered trademarks of Zortrax and are subject to legal protection.
Advertisement
Table of Contents
