Grandstream Networks GWN76 Series User Manual page 64
Wi-fi access points
Hide thumbs
Also See for GWN76 Series:
- User manual (131 pages) ,
- Master/slave architecture manual (15 pages) ,
- User manual (122 pages)
Table of Contents
Advertisement
The following settings can be configured from this page:
Device Name
Set GWN76xx's name to identify it along with its MAC address.
Check this option to configure the device with a static IP configuration; it must be in the same subnet
Fixed IPv4
with the default Network Group; Once enabled, these fields will show up: IPv4 Address/IPv4 Subnet
Mask/IPv4 Gateway/Preferred IPv4 DNS/Alternate IPv4 DNS.
Check this option to configure the device with a static IP configuration; it must be in the same subnet
Fixed IPv6
with the default Network Group; Once enabled, these fields will show up: IPv6 Address/IPv6 Prefix
Length/IPv6 Gateway/Preferred IPv6 DNS/Alternate IPv6 DNS.
Band Steering will help redirecting clients to a radio band 2.4G or 5G, depend on what is supported by
the device, for efficient use and to benefit from the maximum throughput. Four options are allowed by
GWN.Cloud: Disable Band steering: This will disable the band steering feature and the access point
Band Steering
will accept the band chosen by the client. 2G in Priority: 2G Band will be prioritized over 5G Band 5G
in Priority: 5G Band will be prioritized over 2G Band Balance: GWN will balance between the clients
connected to 2G and those connected to 5G. Use Radio Settings: GWN will use the value configured
under Radio page.
You can configure Trunk port or Access port. When it is set to Access, you also need to specify the VLAN
ID. For example, if you have multiple SSIDs on different VLANs, then the port need to be set to Trunk in
Net Port Type
order to negotiate trunk with the switch port where the AP is plugged. Otherwise, if there is only one
SSID/VLAN the port type is set to Access. This feature is not supported in GWN7600/7600LR/GWN7610.
Wi-Fi5
Some old devices do not support Wi-Fi6 well and may not be able to scan the signal or connect poorly.
Compatible
After turning on this switch, it will switch to Wi-Fi5 mode to solve the compatibility problem. At the
Mode
same time, it will turn off Wi-Fi6 related functions. Note: Only take effect for GWN766x(LR).
2.4G & 5G
Used for configuring the advanced settings for 2.4G & 5G.
Disable
This feature allows the user to disable/enable its 2.4GHz band on the AP.
2.4GHz/5GHz
Access Point Configuration Page
Advertisement
Table of Contents
