Table of Contents
Advertisement
hot faces creates both a fire hazard
and damage to the enamel surface.
Catalytic surfaces
• The side walls of the hearth can only be
covered by enamelled or catalytic walls.
It varies according to the model.
• The catalytic walls have a slightly matte
and porous surface. Do not clean the
catalytic walls of the oven.
• The catalytic surfaces absorb oil due to
their porous structure and begin to
shine when the surface is saturated
with oil, in which case it is
recommended to replace the parts.
Glass surfaces
• When cleaning glass surfaces, do not
use hard metal scrapers or abrasive
cleaners. They can damage the glass
surface.
• Clean the appliance with dishwashing
detergent, hot water and a microfiber
cloth specific for glass surfaces and
dry it with a dry microfiber cloth.
• If detergent residue remains after
cleaning, wash it off with cold water
and dry with a clean, dry microfiber
cloth. Detergent residues can damage
the glass surface the next time.
• Dried residue on the glass surface
should never be cleaned with serrated
knives, wire wool or similar scraping
tools.
• Calcium stains (yellow stains) on the
glass surface can be removed with a
descaling agent.
38/EN
available on the market, such as
vinegar or lemon juice.
• If the surface is very dirty, apply the
cleaning product to the stain using a
sponge and wait a long time for it to
work properly. Then clean the glass
surface with a damp cloth.
• Discolorations and stains on the glass
surface are normal and do not show
defects.
Plastic parts and painted surfaces
• Clean plastic parts and painted
surfaces with dish detergent, warm
water and a soft cloth or sponge and
dry with a dry cloth. .
• Do not use hard metal scrapers or
abrasive cleaners. They can damage
surfaces.
• Make sure that the joints of the
components of the appliance are not
left so wet and with detergent.
Otherwise, these seals may corrode
Cleaning accessories
Unless otherwise specified in the user
manual, do not wash the product
accessories in the dishwasher.
Cleaning the control panel
• When cleaning the panels and control
knob, wipe the panel and knobs with a
soft damp cloth and dry them with a
dry cloth. Do not remove the knobs
and seals underneath to clean the
control panel. The control panel and
buttons may be damaged.
Advertisement
Table of Contents
