Cleaning The Oven Light - Beko BBIM13301XPE User Manual

3.Gently lift the inner glass towards
"A" then remove it by pulling
towards "B" as shown in the figure.
1
Interior glass
2
Second inner pane
3
Third inner pane Outer
4
pane
5
Plastic window slot - lower
4.Repeat the same process to remove
the second and third panes.
44/EN
The first step in fitting the door is to
replace the second and third panes
3).
Position the beveled edge of the glass
so that it meets the beveled edge of
the plastic slot as shown in the figure.
The order of attachment of the
second and third interior panes is
not important, since they are
interchangeable.
When attaching the inner glass
be sure to place the printed side of
the pane on the second interior
pane. It is essential! position the
bottom corners of all interior panes
to reach the bottom plastic slots
Push the plastic component towards
the frame until you hear a
A After cleaning, the windows must
be reassembled.
Cleaning the lathe lamp
If the glass door of the cooking zone
oven light is dirty, clean it using dish
detergent, hot water and a soft cloth
or sponge and dry it with a dry cloth. If
the oven light fails, you can replace it
by following the steps below.
(2,
(1),
(5).
click".
"