Powder Calibration - PROALL Mobile Mixer Operator's Manual

1.12.1 POWDER CALIBRATION

3
6
14
1. Menu shortcut. Return to the main menu.
2. Home shortcut. Return to the home screen.
3. Powder or auxiliary calibration can be selected from the list using the touch screen. Once selected the "Name"
will change (see item #4) to show the current type.
4. Up to 5 different types can be selected per powder/auxiliary. Each type having its own unique set of calibration
data. To select the type use the up / down arrow keys until the desired type is shown.
5. Name associated with type 1-5. This name can be edited by touching the value and entering the new name on the
keyboard.
6. Reset trial and trial load pop-up. See page 23.
7. Value of the weight measured for each trial. By touching the field the user can manually enter values using the
keyboard. The number on the bottom left is the calculated auger output for each trial. This is used as a reference
to ensure trials are consistent and correct values are being entered.
8. Value of the counts measured for each trial. By touching the field the user can manually enter the values using
the keyboard.
9. Auger counts. This is the total count of the auger in the trial and is not related to the belt counts.
10. Calibration stop counts can be entered here. These are the counts that the mixer will automatically stop at when
calibrating each trial.
11. Button to activate the calibration stop function.
12. Calculated average output of the auger, based on trial data. This value can also be entered manually if the
calibration data is stored elsewhere.
13. The calculate button should be pressed whenever new data is entered into the trials.
Operator's Manual, Ranger Gunite r1.0
12
7
8
13
10
5
9
1
2
4
11
15
pg. 21