Table of Contents
Advertisement
1.08 MIXER CONTROL
12
13
14
16
15
1. Menu shortcut. Return to the main menu.
2. Home shortcut. Return to the home screen.
3. Auto vibrator set-up times are adjusted here. Total on-time in seconds for each vibrator can be set. VIB1-SAND
Front, VIB2-SAND Back, VIB3-Cement and VIB4-Aux
4. VIB gap time is the delay between each vibrator ON sequence.
5. Momentary Boom Up and Down.
6. Momentary Auger Forward and Auger Reverse.
7. High engine idle trigger.
8. Latched Auger Mix (Latching is done on ECU)
9. Belt / Mix Start.
10. Cement / Aux Unload. Bypasses the belt drive circuit to unload powders only.
11. Momentary Belt Forward.
12. Manually turn oil cooler ON. Typically used to verify oil cooler operation.
13. Manually run chain oiler when belt running. It does not wait for the total belt revolutions cycle to start the
sequence. It will automatically shut-off after 60 seconds of continuous belt operation.
14. Manually run mix auger grease system.
15. Fault reset is a momentary button used to reset/clear any alarms on the display.
16. Level over-ride function. This will over-ride any low-level sensors like cement low or gate material in case of
malfunction or to finish a job.
17. Gates over-ride function. This will allow the operator to temporarily over-ride the gate height sensors. If left on
the belt counts are recorded in the log from start to finish of height over-ride.
Operator's Manual, Ranger Gunite r1.0
5
8
9
17
18
77
6
7
10
11
19
1
3
4
2
pg. 13
Advertisement
Table of Contents
