Installation; Introduction - Installation; Primary Components For Installation; To Prepare For Installation - Husqvarna AUTOMOWER 450X Operator's Manual

3.1 Introduction - Installation

WARNING:
safety chapter before you install the product.
CAUTION:
Use original spare parts and
installation material.
Note:
Refer to www.husqvarna.com for more
information about installation.

3.2 Primary components for installation

The installation includes the components that follow:
• Robotic lawn mower, that cuts the lawn
automatically.
• Charging station, that charges the product.
• Power supply, which is connected to the charging
station and a 100-240V power outlet.
4
• Reference station , that receives satellite signals
and sends correction data to the robotic lawn
mower.
• Mobile device with the Automower
to do the installation and the settings for the
product.

3.3 To prepare for installation

CAUTION:
Holes with water in the lawn
can cause damage to the product.
CAUTION:
Read the installation
chapter before you start the installation.
• Make a blueprint of the work area and include all
obstacles. This makes it easier to examine where
to put the charging station, the reference station,
and the virtual boundaries.
• Make a mark on the blueprint where to put
the charging station, the reference station, the
maintenance point, the transport paths and the
virtual boundaries for the work areas and stay-out
zones.
• Make sure that the work area where the product
operates has unimpeded sky view.
• Fill in holes in the lawn to make it level.
4
Purchased separately.
1970 - 001 - 10.10.2022

3 Installation

Read and understand the
®
Connect app
• Cut the grass before you install the product. Make
sure that the grass is maximum 10 cm / 4 in.
Note:
The first weeks after installation the sound level
when the product cuts the grass can be higher than
usual. The sound level decreases after some time.
3.4 To examine where to put the
reference station
Read and understand the instructions about where to
put the reference station. Refer to the Operator's manual
for the reference station.
3.5 To examine where to put the
charging station
• Put the charging station in an area that you select.
Install a transport path if the charging station is not
in the work area. It is not necessary to install a
transport path if the product is fully in the work area
when it is at the charging station docking point.
• You can put the charging station in an
®
Automower house.
• Keep a minimum 5 m / 16 ft. of free space in front
of the charging station.
• Put the charging station (A) were the docking point
(B) has unimpeded sky view. This means that 110°
of the sky in all directions must be unimpeded. The
product cannot receive satellite signals that is less
than 10% elevation angle. The charging station
docking point (B) is where the product stops after
reversing from the charging station. The reversing
distance can be set to 70-250 cm / 28-98 in.
A
>110°
35° 35°
B
Installation - 11