Husqvarna AUTOMOWER 450X Operator's Manual page 35

Symptoms
The product is parked for
hours in the charging station.
The product moves in circles
or spirals.
The product operates on a
small area for a number of
minutes.
The product cannot connect
to the mobile device.
The cut result is not satisfac-
tory.
1970 - 001 - 10.10.2022
Cause
The product is parked because of the set
Schedule setting, or because Park until
further notice is selected.
The product does not operate if the bat-
tery temperature is too high or too low.
The product operates frequently in
cutting .
The product follows the GPS assisted
navigation.
The product is connected to a different
mobile device or app.
The product operates for a short period.
The work area is too large.
Blunt blades.
Long grass in relation to the set cutting
height.
Collection of grass by the blade disc or
around the motor shaft.
Action
Schedule settings, or start
Change the
the product.
The product starts to operate again when
the temperature is between the set limits
and the schedule settings lets the prod-
uct operate. Make sure that the charging
station is put in an area with protection
from the sun.
Spiral Adjust the intensity of the
or disable it if it is necessary. Refer to
Spiral cutting on page 19 .
Usual operation of the product.
Disable the app in all other connected
devices.
Increase the cutting time. Refer to
Schedule on page 18 .
Increase the intensity level in the
er timer or disable the Weather timer .
Set a limit to the work area, or extend the
operation time. Refer to
schedule setting on page 18 .
Replace all the blades. Refer to
place the blades on page 25 .
Increase the cutting height and then low-
er it when the grass is shorter.
Remove the collection of grass and clean
the product. Refer to
sis and blade disc on page 24 .
Spiral cutting
Weath-
To calculate the
To re-
To clean the chas-
Troubleshooting - 35