Husqvarna AUTOMOWER 450X Operator's Manual page 19

Note:
The operation capacity is approximate and is
calculated for flat and open work area. If the work area
has a lot of slopes or obstacles, you need to increase
the Schedule settings.
Model Approximate operation capaci-
2
ty, m
®
Automower 450X/ 208 / 2240
450XH EPOS
2
Example: A lawn of 3000 m
®
Automower 450X/450XH EPOS.
2
3000 m / 208 ≈ 14.5 h.
2
32000 ft / 2240 ≈ 14.5 h.
Days / week h / day
7 14.5
3.9.2 Cutting height
The cutting height is set individually for each work area.
The cutting height can be set to 20-60 mm / 0.8-2.4 in.
3.9.3 Pattern
The settings for the systematic cutting is set for each
work area. You can do these settings:
• Set the pattern for how the product operates.
• Set the direction of the pattern.
Border mowing where the
• Enable or disable the
product cuts around the work area 2-3 times along
the virtual boundary.
• Set the type of the Border mowing . With Fixed
border mowing the product always operates in
the same paths to keep a sharp border around
Variable border mowing , the
the work area. With
product operates in different paths to decrease the
risk of track marks along the virtual boundary.
3.9.4 Operation
1970 - 001 - 10.10.2022
2
/h / ft /h
2
/ 32000 ft , cut with an
Schedule settings
7:00 - 21:30 / 7:00 am -
9:30 pm
In the Operation's menu it is possible to change the
settings of the Weather timer, ECO mode and Spiral
cutting .
3.9.4.1 Spiral cutting
If the product enters an area where it senses the grass
is longer than average, it can change the movement
Spiral cutting . This means that the product
pattern to
mows in a spiral pattern to faster cut the area with
longer grass. It is possible to set the intensity of the
Spiral cutting . Very low / Low intensity means that Spiral
cutting begins less often. High / Very high intensity
means that Spiral cutting begins more often.
Note:
Spiral Cutting does not start in slopes steeper
than 15%.
3.9.4.2 Weather timer
Weather timer automatically adjust the cutting time to
the growth of the grass. The product is not permitted to
operate more than the schedule settings.
Note:
When using Weather timer , it is recommended
to make as much operating time as possible available
for Weather timer . Do not restrict the schedule more
than necessary.
The first operation of the day is set by the schedule
settings. The product always complete 1 mowing cycle,
Weather timer selects if the product will
and then
continue to operate or not.
Note:
Weather timer is reset if the product does not
operate for more than 50 hours, or if a
settings is done. Weather timer is not changed if a Reset
of schedule settings is done.
3.9.4.3 ECO mode
ECO mode is enabled, it switches off the signal in
If
the charging station, when the product is parked or is
charging.
Reset of all user
Installation - 19