Appendix C - Electrical Interface - SeaLevel ULTRA 485+2.PCI User Manual

Appendix C – Electrical Interface
RS-422
The RS-422 specification defines the electrical characteristics of balanced voltage digital interface
circuits. RS-422 is a differential interface that defines voltage levels and driver/receiver electrical
specifications. On a differential interface, logic levels are defined by the difference in voltage between a
pair of outputs or inputs. In contrast, a single ended interface, for example RS-232, defines the logic levels
as the difference in voltage between a single signal and a common ground connection. Differential
interfaces are typically more immune to noise or voltage spikes that may occur on the communication
lines. Differential interfaces also have greater drive capabilities that allow for longer cable lengths. RS-
422 is rated up to 10 Megabits per second and can have cabling 4000 feet long. RS-422 also defines
driver and receiver electrical characteristics that will allow 1 driver and up to 32 receivers on the line at
once. RS-422 signal levels range from 0 to +5 volts. RS-422 does not define a physical connector.
RS-485
RS-485 is backwardly compatible with RS-422; however, it is optimized for partyline or multi-drop
applications. The output of the RS-422/485 driver is capable of being Active (enabled) or Tri-State
(disabled). This capability allows multiple ports to be connected in a multi-drop bus and selectively polled.
RS-485 allows cable lengths up to 4000 feet and data rates up to 10 Megabits per second. The signal
levels for RS-485 are the same as those defined by RS-422. RS-485 has electrical characteristics that
allow for 32 drivers and 32 receivers to be connected to one line. This interface is ideal for multi-drop or
network environments. RS-485 tri-state driver (not dual-state) will allow the electrical presence of the
driver to be removed from the line. Only one driver may be active at a time and the other driver(s) must be
tri-stated. RS-485 can be cabled in two ways, two wire and four wire mode. Two wire mode does not allow
for full duplex communication, and requires that data be transferred in only one direction at a time. For
half-duplex operation, the two transmit pins should be connected to the two receive pins (Tx+ to Rx+ and
Tx- to Rx-). Four wire mode allows full duplex data transfers. RS-485 does not define a connector pin-out
or a set of modem control signals. RS-485 does not define a physical connector.
19
© Sealevel Systems, Inc. 7204 Manual | SL9061 7/2021