Connectors - Supermicro H12DGQ-NT6 User Manual

2.5 Connectors

TPM Header/Port 80 Connector
The JTPM1 header is used to connect a Trusted Platform Module (TPM), which is available from
a third-party vendor. A TPM is a security device that supports encryption and authentication in
hard drives. It enables the motherboard to deny access if the TPM associated with the hard
drive is not installed in the system.
Please go to the following link for more information on TPM:
manuals/other/TPM.pdf.
SATA Ports
The H12DGQ-NT6 supports four SATA 3.0 ports through P0-SATA0~3, P2-SATA0~3, and
P2-SATA4~7 ports and HDD backplane board BPN-SAS3-LB16A-N10 with a specific cable.
NVM Express Connections
Te n N V M E x p r e s s p o r t s v i a f i v e S l i m S A S x 8 p o r t s a r e l o c a t e d o n
the serverboard (from PLX). These ports provide high-speed, low-latency PCIe
4.0 x4 connections directly from the PLX
IPMB System Management Bus Header
A System Management Bus header for IPMI 2.0 is located at JIPMB1. Connect the appropriate
cable here to use the IPMB I
Trusted Platform Module Header
Pin Definitions
Pin# Definition Pin#
1 LCLK 2
3 LFRAME# 4
5 LRESET# 6
7 LAD3 8
9 3.3V 10
11 LAD0 12
13 NC 14
15 3.3V_STBY 16
17 GND 18
19 NC 20
C connection on your system.
2
IPMB Header
Pin Definitions
Pin# Definition
1 Data
2 Ground
3 Clock
4 No Connection
35
Chapter 2: Installation
http://www.supermicro.com/
Definition
GND
NC
LAD2
LAD1
GND
NC
SERIRQ
NC
NC
to NVMe Solid State Drives (SSD).