Supermicro H12DGQ-NT6 User Manual page 62

H12DGQ-NT6 User's Manual
Data Bits
Use this feature to set the data transmission size for Console Redirection. The options
are 7 and 8.
Parity
A parity bit can be sent along with regular data bits to detect data transmission errors.
Select Even if the parity bit is set to 0, and the number of 1's in data bits is even. Select
Odd if the parity bit is set to 0, and the number of 1's in data bits is odd. Select None
if you do not want to send a parity bit with your data bits in transmission. Select Mark
to add a mark as a parity bit to be sent along with the data bits. Select Space to add a
Space as a parity bit to be sent with your data bits. The options are None, Even, Odd,
Mark, and Space.
Stop Bits
A stop bit indicates the end of a serial data packet. Select 1 Stop Bit for standard serial data
communication. Select 2 Stop Bits if slower devices are used. The options are 1 and 2.
CPU Configuration
SMT Control
Use this setting to specify Simultaneous Multithreading. Options include Disabled for 1T
single thread and Auto for 2T two-thread if your system is capable of it.
Core Performance Boost
This setting is used to configure for Core Performance Boost. Options include Disabled
and Auto.
Global C-state Control
This setting is used to configure for Global C-state Control. Options include Disabled,
Enabled and Auto.
Local APIC Mode
Use this setting to adjust local APIC mode. Options include Compatibility, xAPIC, x2APIC
and Auto.
CCD Control
Use this setting to disable CCDs in the CPU. Options include Auto, 2 CCDs, 3 CCDs, 4
CCDs and 6 CCDs.
Core Control
This sets the number of cores to be used by your system. Once this option has been used
to remove any cores, a power cycle is required in order for the future selections to take
62