Table of Contents
Advertisement
Chapter 2 Getting Started — Attaching/removing the projection lens
Removing the projection lens
Remove the projection lens using the following procedure.
Lens fixing screw
Fig. 1
Top slide cover
Fig. 3
1)
Remove the lens fixing screw.
f For a projection lens other than the Zoom Lens (Model No.: ET-EMU100), remove the screw on the right of
the projection lens using a ball point hex driver. (Fig. 1)
f For the Zoom Lens (Model No.: ET-EMU100), remove the lens fixing screws (4 locations) around the
projection lens using the ball point hex driver supplied with the Zoom Lens (Model No.: ET-EMU100).
(Fig. 2)
2)
Remove the top slide cover. (Fig. 3)
f Slide the top slide cover until the top slide cover attachment line is visible.
Once the top slide cover attachment line is visible, remove it by lifting.
3)
While holding the projection lens, pinch the lens lock lever and turn to the Unlock side. (Fig. 4)
4)
Remove the projection lens. (Fig. 5)
5)
Attach the top slide cover. (Fig. 3)
f Align the top slide cover with the top slide cover attachment line, and attach it by sliding.
Attention
f Store the removed projection lens where it will be free from vibration and impact.
f Store the removed lens fixing screw in a safe place.
Lens fixing screws
Top slide cover attachment line
Fig. 2
Lens lock lever
Fig. 4
Lens fixing screws
Fig. 5
ENGLISH - 47
Advertisement
Table of Contents
