Table of Contents
Advertisement
[Projector control]
[Basic control] page
Click [Projector control] → [Basic control].
1
[POWER]
Turns off/on the power.
2
[SHUTTER]
Switches the status of the shutter. ([CLOSE]: Shutter function
enabled; [OPEN]: Shutter function disabled)
3
[OSD]
Switches the status of the on-screen display function.
([OFF]: Hide; [ON]: Display)
4
[SYSTEM]
Switches the system method.
[Detail control] page
Click [Projector control] → [Detail control].
1
Control of the projector
The projector is controlled by clicking the buttons in the same
way as the buttons on the remote control. After control, the on-
screen display of the projector at the right of the control page is
updated.
2
[SUB MEMORY]
Switches the sub memory.
3
[SYSTEM DAYLIGHT VIEW]
Switches the system daylight view settings.
4
[FREEZE]
Temporarily pauses the image.
5
[WAVEFORM MONITOR]
Displays the waveform of the input signal.
6
[PROJECTION METHOD]
Switches the setting of the projection method.
Chapter 5 Operations — Web control function
1
2
3
4
5
6
1
2
3
4
5
6
5
On-screen display of the projector
Displays the same items as shown on the on-screen display
of the projector. You can check or change the settings of the
menus. It is displayed even if the on-screen display function is
set to off (hide).
However, the contents of the on-screen display is not updated if
accessed with the standard user account.
6
[INPUT SELECT]
Switches the input signal.
7
8
9
10
11
7
[OSD POSITION]
Switches the OSD position setting.
8
[GEOMETRY]
Switches the geometric adjustment setting.
9
[LENS]
Displays the [LENS] page.(x page 194)
10 [TEST PATTERN]
Displays the test pattern.
Click the test pattern to display in the projected image from the
patters displayed on the right side of the control page.
The display of the test pattern disappears if [Exit] is clicked.
11 [GET OSD]
Updates the on-screen display of the projector at the right of the
control page.
ENGLISH - 191
Advertisement
Table of Contents
