Installation; Cable Preparation; Installing Camera; Optional) Installing Sd Card - Dahua TPC-SD2221-TB3F4 Quick Start Manual

Make sure the mounting surface is strong enough to hold at least eight times of the camera

weight.
 The following figure is for reference only, and the actual product shall prevail.
4.1

Cable Preparation

Selecting Needed Video Cable
 75 ohm.
 Full cable with copper conductor.
 95% knitted copper shield.
International Model
RG59/U
RG6/U
RG11/U
Selecting Needed Power Cable
It is recommended to install the matched power within 5m from the device if it is allowed; but if
not, then it needs to extend the power supply cable, but it has to guarantee the voltage of the
device input port (thermal hybrid dome output cable) is no lower than 12V±20% DC.
Selecting Needed Signal Cable
All signal cables (audio, alarm input and output and RS-485 etc.) are recommended to use
0.56mm (24AWG) and above cable as lengthened wire signal cable.
4.2

Installing Camera

4.2.1 (Optional) Installing SD Card

Please cut off the device power before installing SD card.

Be cautious and do not mistake Micro SD card slot for reset hole. Long press the reset

button for 4 seconds–5 seconds and you will reset your Camera.
4
Table 4-1 Video cable
Max Transmission Distance (Ft/M)
750Ft/229M
1,000Ft/305M
1,500Ft/457M

Installation

Installation 9