Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Dahua DH-TPC-BF8620-T
Summary of Contents for Dahua DH-TPC-BF8620-T
- Page 1 Thermal Hybrid Bullet Camera Quick Start Guide Version 1.0.0...
-
Page 2: Table Of Contents
Table of Contents ACCESSORY LIST ..................... 1 DEVICE STRUCTURE ..................2 Device External Cable .......................... 2 Device Dimension ..........................3 DEVICE INSTALLATION ..................4 Installation Preparation ......................... 4 3.1.1 Check installation space and intension ..................4 3.1.2 About cable ............................4 Installation Steps ........................... - Page 3 Welcome Thank you for purchasing our thermal hybrid dome! Please read the following safeguards and warnings carefully before you install or use the product!
- Page 4 Important Safeguards and Warnings Safety Measures 1. Qualified Engineer Needed The installation engineer or maintenance engineer shall have corresponding CCTV system installation certificate or maintenance qualification certificate. The installation engineer or maintenance engineer shall have qualification certificate for work at height.
- Page 5 Warning: It is to alert you there is an optional risk of death or series injury! Note: It is to alert you there is an optional risk of damage or property loss! Warning Be sure to use all the accessories (such as power adapter) recommended by manufacturer. Do not connect several thermal hybrid domes to one power adapter.
- Page 6 The above mentioned objects in the device may result in fire, short-circuit or damage. Please shut down the device and disconnect the power cable if there is water or liquid falling into the camera. Please contact your local retailer ASAP. ...
-
Page 7: Accessory List
1 Accessory List Please check if there is any obvious damage to the device appearance when opening the external packing box, besides, you need to confirm if the accessories are in accordance with the ones on the list. Please refer to sheet 1-1 for the accessories; please be aware that the actual config is based on the specific product. -
Page 8: Device Structure
2 Device Structure 2.1 Device External Cable The device external cable is shown in Figure 2-1. Figure 2-1 Please refer to sheet 2-1 for more details about the external cable. SN Port Port name Connector Note ALARM_OUT1 Alarm output port 1, output alarm signal to alarm device. -
Page 9: Device Dimension
SN Port Port name Connector Note RS485 RS485 RS485 port, control external PTZ etc. port Power port, input AC 24V. Power Note: POWER input port Actual use is accordance with the instruction of device label. Sheet 2-1 Note: Please use the connector in the accessories bag to insert into the network port before device power on, at this moment, BNC outputs HDCVI signal. -
Page 10: Device Installation
3 Device Installation 3.1 Installation Preparation 3.1.1 Check installation space and intension Please make sure the installation environment has enough space to install the PTZ and its corresponding bracket. Please make sure the ceiling, wall and the bracket can support the total weight of PTZ and its corresponding installation component, it is required to be equipped with 8 times of safety factor. - Page 11 Dig four installation hole sites according to the installation holes of the bracket, please be aware that the hole size and depth need to match those of the expansion bolt, make sure there is no deviation for the hole sites, please refer to Figure 3-1 for more details. Figure 3-1 Step 3 Take out M8 expansion bolt from the accessories bag, knock the expansion bolt into the holes...
- Page 12 Figure 3-2 1. Keep the convex groove outward and install the rubber ring into the network port, keep the smaller hole of the rubber ring outward and install the fixing rubber ring into the main body of the waterproof connector. 2.
- Page 13 Note: Make sure to loosen the adjusting screw when adjusting the device direction and angle, tighten the adjusting screws firmly after the adjustment is completed. Please do not rotate the camera body more than 360°when the device body and installation chassis form an angle of 90°and the adjusting screws are in the condition of being firmly tightened.
-
Page 14: Network Configuration
4 Network Configuration 4.1 Modify IP Address IP address can be acquired and modified through quick configuration tool for the thermal hybrid dome (the default IP address is: 192.168.1.108), please refer to the << Quick Configuration Tool Operation Manual>> for more details. Users can modify device IP via this method when they forget the device IP. -
Page 15: Login Web Interface
Step 4 Modify the camera IP address on the “Net” interface, click “Save” to finish modification. See Figure 4-2 for more details. Figure 4-2 4.2 Login WEB Interface Note: Different devices may have different WEB interfaces, the figures below are just for reference, please refer to the <<WEB Operation Manual>>... - Page 16 Figure 4-3 Step 2 The login interface is shown below; please input your user name and password (Default user name is admin and password is admin respectively), click “login”. See Figure 4-4 for more details. Step 3 Install controls according to the system prompt; see Figure 4-4 for the WEB main interface. Please modify the administrator password as soon as possible after you successfully logged in.
- Page 17 5 APPENDIX Ⅰ LIGHTENING PROTECTION AND SURGE PROTECTION This series thermal hybrid dome adopts TVS lighting protection technology. It can effectively prevent damages from various pulse signals below 6000W, such as sudden lighting and surge. While maintaining your local electrical safety code, you still need to take necessary precaution measures when installing the thermal hybrid dome in the outdoor environment.
- Page 18 Note This manual is for reference only. Slight difference may be found in the user interface. All the designs and software here are subject to change without prior written notice. All trademarks and registered trademarks are the properties of their respective owners.