ohmex DUETTO PLUS Instruction Manual page 93

DUETTO PLUS
PREPARATION OF THE APPLIANCE
Make sure that the auger (H) is fitted on the
teflon coating and the metal washer (X) and
that these are intact. Otherwise, replace
them by going to a point of sales.
a4 - Insert the auger (H) in the infeed duct (B) attaching
it to the motor pin.
a5 - Insert the extended conical auger (G) on the auger
(H).
a6 - Insert the conical sieve (C) in the infeed duct (B)
positioning it as illustrated.
a7 - Tighten the ring nut (O) using your hands.
While tightening the nut (O) with the other
hand hold the infeed duct (B).
X
H
B
H
H
G
B
C
B
O
EN
89