Advertisement
Congratulations on your new SCAN stove!
You have chosen a product from one of Europe's leading manufacturers of wood-burning stoves. We are convinced
that your stove will be to your full satisfaction and give you many hours of pleasure if you follow the advice and
instructions of this manual.
Please read this manual as well as the General Instructions for Installation before beginning the installation.
Clean combustion
The SCAN 47-2 uses the "CB technique"
(Clean-Burn) to ensure an optimally clean
combustion. The extra combustion air is pre-
heated and led into the combustion chamber
close to the ceramic smoke deflector.
3
4
2
1 Ashtray. When you open the lower door, you have
access to the ashtray, which is placed below the com-
bustion chamber. Attention! Be careful when you empty
ashes from the stove. There may be embers left for up
to 24 hours after the stove was last used.
2 Lid for ashtray. Under the ashtray you will find a lid
to put on top of the ashtray when you carry it out for
emptying.
3 Handle for shaking grate. The stove is equipped with
a shaking grate. When you activate the grate handle,
the ashes from the combustion chamber are emptied
into the ashtray.
SCAN 47-2
Ceramic smoke deflectors
Lift up the lower ceramic smoke deflector, pull out
the pins in the lateral combustion chamber plates
and remove the deflector. The upper deflector is
removed in the same way.
4 Regulation for primary air. Turn the air valve in order
to open. The primary air is used when lighting and
refuelling the stove. It should always be closed during
continuous firing.
5 Regulation for combustion air. Push the button side-
ways. Left position is closed and right position is open.
The air is used for combustion and regulates the output
of the stove.
The ashtray, shaking grate, and primary air should always
be closed during continuous firing.
1
5
Advertisement
