Necessary Steps When Installing The Ust-Lens On The G60/G62 - Barco G62 Series Installation Manual

UST lens R9801785(1)
3.5 Necessary steps when installing the UST-lens
on the G60/G62
Handle as follow
1. Software preparation of the projector to receive the UST lens.
1. First you need to put the lens holder in the position suited for the UST-lens and the brightness needs to
be reduced during the setup process. This is initiated by pressing a series of keys on the local keypad
or on the remote control unit. The software will do the rest automatically.
2. After the setup and calibration is done, you need to let the projector know that the setup is done. After
this command, the projector will switch off and it will know the setup is done. The lens shift is then fixed
and the brightness is again put at maximum.
2. Mechanical preparation of the projector to receive the UST lens.
In this part, a lot of steps need to be done to correctly install the UST-lens.
3. Adjust the lens optically.
In this part, the UST lens is adjusted in sheimpflug and back focal distance by using the correct procedure.
40 R5914654 /04 G62 series