Barco G62 Series Installation Manual page 87

3
1
Image 6–9
Note: This process may cause the other areas of the image to slide out of focus. This is totally
normal.
5. After the above adjustment of the viewing axis, the projected image from zone A to zone I still cannot
achieve a clear focus on the screen. Please turn the boresight screws ① to ③ counterclockwise to the end
(STOP), and then turn clockwise 2 circles to the design value position. To improve the focus, go to step 2
and repeat the complete procedure.
2
Adjusting the projected image
R5914654 /04 G62 series 87