Barco G62 Series Installation Manual page 69

Fixate the adapter plate with 3 screws M4x10 to the lens. To continue, go to step 8.
Image 4–13
6. For up projection: adapt the lens clamp module. Remove the lens clamp part from the lens clamp module
by removing the 3 screws
screws M4x10 (Image
Image 4–15
7. Mount the safety bar with 2 screws M4x10 on the side of the lens (reference 1 & 2 in
safety bar will be used to mount the safety cable. To continue, go to step 9
2
1
Image 4–17
8. Turn the projector up side down and mount the safety bar with 2 screws M4x10. This safety bar will be
used to mount the safety cable.
(Image 4–15. Just mount the lens clamp part on the lens holder module using 2
4–16. Tighten with a torque between 3.5 and 9.8 Nm
UST lens R9801830 G lens (0.37 - 0.40 : 1) UST 90°
Image 4–14
Image 4–16
Image 4–17). This
R5914654 /04 G62 series 69