Barco G62 Series Installation Manual page 22

Installation
2
Image 2–3
3. Snap the first loop end of the safety cable into one of the following clips and let the loop end point
downwards.
1. Configuration A: Use the upper clip on the side of the cable bundle (reference 2,
2. Configuration B: Use the upper clip on the non-wired side (reference 2,
4. Slide the rest of the cable around the lens counterclockwise. Click the cable into every clip it passes in this
loop.
Note: Make sure the cable passes between the lens and the cable bundle.
5. Slide the cable through the loop end at the beginning of the cable to create a lasso..
Image 2–5 Example of configuration A
6. Pull the lasso tight around the lens body and install the U-bolt on the lens holder, with the open ends
oriented outwards (reference 3). Make sure that both a part of the loop end and the outgoing part of the
safety cable are placed in the enclosure.
22 R5914654 /04 G62 series
1
Image 2–4
2
1
Image 2–3).
Image 2–4).