Barco G62 Series Installation Manual page 85

3
1
Image 6–7
Note: This process may cause the other areas of the image to slide out of focus. This is totally
normal.
3. If zone D is in focus on the screen, please check the focal plane of zone E.
• If clear position is just on the screen→ No need to adjust.
• If clear position is out of the screen(cloe to projector), rotate screw ② CCW and then screw ① &③ CW
for half amount that ② rotated. → repeat until both D and E are clear. (e.g. turning ② CCW in a circle,
then turn ① &③ CW in half circle)
• If clear position is in the screen(far from projector), rotate screw ② CW and then screw ① &③ CCW for
half amount that ② rotated. → repeat until both D and E are clear.
2
Adjusting the projected image
R5914654 /04 G62 series 85