Siemens SIMATIC S7-1500 System Manual page 382

Glossary
Parameter
• Tag of a STEP 7 code block:
• Tag for setting the behavior of a module (one or more per module). In as-delivered state,
every module has an appropriate basic setting, which you can change by configuring in
STEP 7. There are static and dynamic parameters
Parameters, dynamic
You can change dynamic module parameters during operation by calling an SFC in the user
program, for example, limits of an analog input module.
Parameters, static
You cannot change static module parameters with the user program, but only with
configuration in STEP 7, for example, the input delay of a digital input module.
PELV
Protective Extra Low Voltage = safety extra low voltage connected to protective earth
Pre-wiring
Wiring of the front connector in the "pre-wiring position" at the I/O module or before you
insert the front connector into the I/O module.
Primary CPU
Role of a CPU in the S7-1500R/H redundant system. If the R/H system is in the RUN-Redundant
system state, the primary CPU controls the process. The backup CPU processes the user
program synchronously and can take over process control if the primary CPU fails.
Primary-backup switchover
The primary CPU has the leading role within the redundant system. If the primary CPU fails
following a fault, the backup CPU takes over the primary role and operates as the primary
CPU.
Process image (I/O)
The CPU transfers the values from the input and output modules to this memory area. At the
start of the cyclic program, the CPU transfers the process image output as a signal state to the
output modules. The CPU then reads the signal states of the input modules into the process
image inputs. The CPU then executes the user program.
Product version (PV) = Function version (FV)
The product version or function version provides information on the hardware version of the
module.
382
S7-1500R/H redundant system
System Manual, 11/2022, A5E41814787-AD