Siemens SIMATIC S7-1500 System Manual page 152

Application planning
5.7 Using HMI devices
Connecting HMI devices over Industrial Ethernet, example with CPU 1513R‑1 PN
The figure below shows how to connect an HMI device over Industrial Ethernet with the
CPU 1513R‑1 PN.
Figure 5-50 Configuration example CPU 1513R-1 PN: Connecting the HMI device via a switch
CPU 1513R‑1 PN has a PROFINET IO interface with 2 ports (X1 P1R R and X1 P2R).
To connect an HMI device to the CPUs over Industrial Ethernet, you set up the PROFINET ring
over PROFINET interface X1. Integrate a switch into the PROFINET ring. Use this to establish
an Industrial Ethernet connection.
You can find additional information on the interfaces of CPU 1513R‑1 PN in the relevant
device manual.
Reference
You can find more information on the system IP address in the section Configuration process
and in the Communication (https://support.industry.siemens.com/cs/ww/en/view/59192925)
function manual.
More information on how to set up an HMI connection to the S7-1500R/H redundant system
is available in the Communication
(https://support.industry.siemens.com/cs/ww/en/view/59192925) function manual.
See the following entry (https://support.industry.siemens.com/cs/ww/en/view/109781687)
for an example of how to connect an HMI device with S7-1500R/H.
152
S7-1500R/H redundant system
System Manual, 11/2022, A5E41814787-AD