Installation; Introduction; Installation Documents; Notes On Mechanical Surface Mounting - Eaton DX-NET-PROFINET2-2 Manual

3 Installation

3.1 Introduction

3.2 Installation documents

3.3 Notes on mechanical surface mounting

This chapter provides a description of the mounting and the electrical con-
nection for the DX-NET-PROFINET2-2 communication interface.
￫
Perform all installation work only with the indicated, appropriate
tools and do not apply any force.
The following documents provide information on installing a DC1 variable
frequency drive (with degree of protection IP20) or a DE1 variable speed
starter:
Series
DC1 variable frequency drive with degree of protection IP20
DC1 variable frequency drive with degree of protection IP20,
frame size FS4
DE1 variable speed starter
Observe the following information when setting up the system.
DANGER

All handling and installation work relating to the mechanical
surface mounting and installation of the DX-NET-PROFINET2-2
communication interface may only be carried out in a voltage-
free state.

D C -
L1 /L L2 /N
L3
Figure 10: Only carry out installation work in a voltage-free state
DX-NET-PROFINET2-2 01/22 MN040062EN www.eaton.com
3 Installation
3.1 Introduction
Document
Instruction leaflet IL04020009Z
Instruction leaflet IL040024ZU
Instruction leaflet IL040005ZU
21