Installation; General Information; Mechanical Installation - Eaton Crouse-hinds series Instruction Manual

5
10
DRAFT - 04 March 2016

INSTALLATION

5 .1

General information

The 'Safety guidelines and provisions' and 'Installation and Connection
Instructions' must be studied and strictly adhered to in order to ensure
The installation may only be carried out by trained specialists who have
the appropriate training certification. These personnel must be able to
demonstrate familiarity with the specific nature of potentially explosive
All ground connections must be wired prior to commissioning.
The connection points are labelled with the symbol
shown here on the right.
5 .2

Mechanical installation

The MTL GECMA RT COM module is designed to fit on the rear panel of the WS
display module as shown on the right of the picture below.
Rear view of an enclosure showing the RT COM module and
It is attached via a number of studs that protrude from the back of the display panel.
Fit the RT COM module over the studs then fasten it with x6 M4 self locking nuts.
Tighten the nuts to the recommended torque value of 1.5-2.0 Nm.
WARNING!
safe and reliable operation.
WARNING!
atmospheres.
WARNING!
other related components
INM MTL GECMA RT COM rev 2