Install Temperature Probe
(continued)
Thermo Fisher Scientific
3. Carefully remove the existing Permagum sealant from around the
probe port opening.
Figure 5-4. Probe Access Port
4. Open the freezer lid and locate the probe cover on the upper front left
wall. Remove the two Phillips head screws securing the probe cover
(see Figure 5-5).
5. Route the BUS probe through the probe port, approximately 12".
Secure the back-up probe to the temperature probe using a small tie
wrap (Figure 5-5).
Figure 5-5. Probe location
6. Seal around the interior and exterior opening of the probe port with
Permagum sealant.
7. Reinstall the probe cover (Figure 5-5).
Section 5
Factory Installed Options
7010708
5-3