Hardware Installation; Precautions - Basler dart Quick Installation Manual

Quick Installation Guide for Basler dart Cameras

2.2 Hardware Installation

2.2.1

Precautions

Electric Shock Hazard
Non-approved power supplies may cause electric shock. Serious injury or death
may occur.
You must use a camera power supply which meets the Safety Extra Low

Voltage (SELV) and Limited Power Source (LPS) requirements.
If you use a powered hub as part of the USB 3.0 connection, you must use a

powered hub that meets the SELV and LPS requirements.
Fire Hazard
Non-approved power supplies may cause fire and burns.
You must use a camera power supply which meets the Limited Power Source

(LPS) requirements.
If you use a powered hub as part of the USB 3.0 connection, you must use a

powered hub that meets the LPS requirements.
Dust on the sensor can impair the camera's performance.
Every time you handle the camera without a lens attached, make sure that the camera is

pointing down so that no dust can reach the sensor.
If the camera is not installed, store it in its original packaging.

Heat can damage the camera.
Make sure that you provide sufficient heat dissipation to keep the operation temperature of the
device at the maximum value or below as specified for the camera during operation. For more
information about the temperature requirements and about providing heat dissipation, see the
Basler dart User's Manual for USB 3.0 Cameras (AW0001305).
6
DANGER
WARNING
NOTICE
NOTICE
AW00130404000
Basler dart