Installing The Host Controller Driver - Basler dart Quick Installation Manual

AW00130404000
2.1.2

Installing the Host Controller Driver

Installation Under Windows 7
If you are using a USB 3.0 host controller with a
Renesas USB 3.0 chipset to operate your dart camera, follow the instructions

below.
non-Renesas USB 3.0 chipset to operate your dart camera, make sure to

obtain and install a compatible xHCI driver from the manufacturer. After driver
installation, proceed with the hardware installation in Section 2.2 on
'
To install a driver for host controllers using Renesas USB 3.0 chipsets:
1. Click Start > All Programs > Basler > pylon 4 Camera Software Suite >
Tools & Drivers > USB 3.0 Host Controller Drivers.
The USB 3.0 Host Controller folder opens showing the xHCI driver setup packages and a
Readme.txt file. The readme file includes information about the matching driver setup for each
variant of the Renesas host controller chipset.
2. Install the matching xHCI driver setup package for the Renesas host controller chipset.
If you are not sure which chipset is used, install both xHCI driver setup
packages that are delivered with the Basler pylon Camera Software Suite.
If the host controller uses a Renesas µPD720200 or µPD70200A chipset:

a. Click Renesas-USB3-Host-Driver-21390-setup.exe to install the matching xHCI driver
setup package.
If the host controller uses a Renesas µPD720201 or µPD720202 chipset:

a. Click Renesas 3.0.23.0.zip to unpack the matching xHCI driver setup.
b. Click Renesas-USB3-Host-Driver-30230-setup.exe to install the matching xHCI driver
setup package.
The matching xHCI driver is installed.
Installation Under Windows 8 or 8.1
Use the xHCI driver that is included in the Windows 8 or Windows 8.1 operating system on your
PC. The xHCI driver is suitable for all brands of host controller chipsets for USB 3.0 ports. The driver
needs not explicitly be installed.
Basler dart
Quick Installation Guide for Basler dart Cameras
page 6.
5