Dodge R1500 1999 Service Manual page 308

POWER DOOR LOCK SYSTEM
DOOR LOCK SWITCH FAILURE (PDL)
NOTE: For connector terminal identification and wiring diagrams,
see BODY CONTROL COMPUTER - INTRODUCTION article. Perform
VERIFICATION TEST VER-1A after each repair.
CAUTION: Always turn ignition switch to OFF position prior to
disconnecting or connecting any module connector.
1) Clear trouble codes as needed. See BODY CONTROL COMPUTER -
INTRODUCTION article. Using scan tool, read I/O's door lock switch
status. If scan tool displays PRESSED, go to next step. If scan tool
does not display PRESSED, system is currently functioning properly.
2) Disconnect left door lock switch connector. If scan tool
displays PRESSED, go to next step. If scan tool does not display
PRESSED, replace left door lock switch.
3) Disconnect right door lock switch connector. If scan tool
displays PRESSED, go to next step. If scan tool does not display
PRESSED, replace right door lock switch.
4) Locate Central Timer Module (CTM). CTM is located under
left side of instrument panel. Disconnect CTM 18-pin connector C2.
Using an external voltmeter, measure voltage between ground and CTM
18-pin connector C2 terminal No. 4 (Orange/Dark Green wire). If
voltage is more than 1.5 volts, repair short to voltage in Orange/Dark
Green wire. If voltage is 1.5 volts or less, replace CTM.
DOOR UNLOCK SWITCH FAILURE (PDL)
NOTE: For connector terminal identification and wiring diagrams,
see BODY CONTROL COMPUTER - INTRODUCTION article. Perform
VERIFICATION TEST VER-1A after each repair.
CAUTION: Always turn ignition switch to OFF position prior to
disconnecting or connecting any module connector.
1) Clear trouble codes as needed. See BODY CONTROL COMPUTER -
INTRODUCTION article. Using scan tool, read I/O's door unlock switch
status. If scan tool displays PRESSED, go to next step. If scan tool
does not display PRESSED, system is currently functioning properly.
2) Disconnect left door lock switch connector. If scan tool
displays PRESSED, go to next step. If scan tool does not display
PRESSED, replace left door lock switch.
3) Disconnect right door lock switch connector. If scan tool
displays PRESSED, go to next step. If scan tool does not display
PRESSED, replace right door lock switch.
4) Locate Central Timer Module (CTM). CTM is located under
left side of instrument panel. Disconnect CTM 18-pin connector C2.
Using an external voltmeter, measure voltage between ground and CTM
18-pin connector C2 terminal No. 13 (Pink/Dark Green wire). If voltage
is more than 1.5 volts, repair short to voltage in Pink/Dark Green
wire. If voltage is 1.5 volts or less, replace CTM.
AUTOMATIC (ROLLING) DOOR LOCKS INOPERATIVE
NOTE: For connector terminal identification and wiring diagrams,
see BODY CONTROL COMPUTER - INTRODUCTION article. Perform
VERIFICATION TEST VER-1A after each repair.
1) Using scan tool select SYSTEM MONITORS, then CCD BUS TEST.
If scan tool displays BUS OPERATIONAL, go to next step. If scan tool