Dodge R1500 1999 Service Manual page 105

panel. To install, reverse removal procedure.
Fig. 6: Removing Cluster Bezel (Ram Pickup)
Courtesy of Chrysler Corp.
ACCUMULATOR
Removal & Installation
1) Disconnect negative battery cable. Discharge A/C system,
using approved refrigerant recovery/recycling equipment. Disconnect
clutch cycling pressure switch connector.
2) On Dakota, remove nuts securing cruise control servo
mounting bracket to studs on cowl plenum panel (if equipped). Move
servo far enough to access accumulator refrigerant lines.
3) On all models, disconnect refrigerant lines from A/C
compressor and evaporator. Plug or cover all openings in A/C system.
Loosen support bracket screw. Remove accumulator.
4) To install, reverse removal procedure. Install new "O"
rings. Evacuate and charge A/C system.
BLOWER MOTOR
Removal (Dakota & Durango - Front)
1) Disconnect negative battery cable. Remove and disassemble
A/C-heater assembly. See A/C-HEATER ASSEMBLY. Disconnect blower motor
lead at bottom of housing. Remove 6 screws and blower motor housing
cover.
2) Remove 3 screws and blower motor and fan assembly. Place
reference marks on blower motor and fan for reassembly reference.
Remove blower fan retainer clip. Pull blower motor fan off blower
motor shaft.
Installation
Align reference marks. Press blower fan hub onto blower motor
shaft. Ensure retainer clip ears are indexed over flats of blower
motor shaft and fan hub. To complete installation, reverse removal