Dodge R1500 1999 Service Manual page 942

1999 ENGINE PERFORMANCE
CHRY - Removal, Overhaul & Installation - Gasoline
Dakota, Durango, Ram Pickup, Ram Van, Ram Wagon
CAUTION: When battery is disconnected, vehicle computer and memory
systems may lose memory data. Driveability problems may exist
until computer systems have completed a relearn cycle. See
COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION
before disconnecting battery.
INTRODUCTION
Removal, overhaul and installation procedures are covered in
this article. If component removal and installation is basically an
unbolt and bolt-on procedure, only a torque specification may be
provided.
COMPUTERIZED ENGINE CONTROLS
POWERTRAIN CONTROL MODULE (PCM)
NOTE: If replacing Powertrain Control Module (PCM), the correct
vehicle mileage and Vehicle Identification Number (VIN) must
be programmed into the PCM to prevent Diagnostic Trouble
Codes (DTCs) from being set in the Anti-Lock Brake System
(ABS) module and Supplemental Restraint System (SRS) module.
To program PCM and clear DTCs from ABS and SRS modules, see
PCM PROGRAMMING. If replacing Powertrain Control Module (PCM)
on models equipped with a Smart Key Immobilizer Module
(SKIM), the secret key data must also be updated to enable
engine starting. To update secret key data, see PCM
PROGRAMMING.
Removal & Installation
1) PCM is located in the engine compartment. See Figs. 1-3.
Disconnect negative battery cable. Remove cover for access to
electrical connectors at PCM. Disconnect electrical connectors from
PCM. Remove PCM retaining bolts and PCM.
2) To install, reverse removal procedure. Tighten PCM
retaining bolts to specification. See TORQUE SPECIFICATIONS.
Fig. 1: Locating PCM (Dakota & Durango)
Courtesy of Chrysler Corp.
N - REMOVE/INSTALL/OVERHAUL - RWD - GASOLINE
1999 Dodge Pickup R1500