Dodge R1500 1999 Service Manual page 110

TEMPERATURE CONTROL CABLE R & I
Removal (Dakota & Durango)
Disconnect negative battery cable. Disconnect but DO NOT
remove instrument panel. See INSTRUMENT PANEL. Disconnect temperature
control cable from A/C-heater control panel. Disconnect temperature
control cable from flag retainer located at top of A/C-heater assembly
housing. See Fig. 7. Remove temperature control cable self-adjuster
clip and temperature control cable.
Installation
1) Before installing temperature control cable, ensure that
self-adjuster clip is positioned as indicated. See Fig. 8.
Measurements must be made with cable end bottomed against flag
retainer on A/C-heater control panel end of cable housing.
2) Measure distance between center of self-adjusting clip and
end of cable flag retainer. If distance is not as specified, adjust
self-adjuster clip. To complete installation, reverse removal
procedure.
Fig. 7: Removing Control Cable Flag From Receiver (Typical)
Courtesy of Chrysler Corp.
Fig. 8: Adjusting Temperature Control Cable (Dakota & Durango)
Courtesy of Chrysler Corp.