Dodge R1500 1999 Service Manual page 955

TRANSMISSION TEMPERATURE SENSOR
Removal & Installation (A/T Models)
Transmission temperature sensor is located on transmission
valve body, incorporated into governor pressure sensor. See
appropriate ELECTRONIC CONTROLS article in AUTOMATIC TRANSMISSIONS
section.
UPSTREAM OXYGEN SENSOR
NOTE: Upstream oxygen sensor may also be referred to as pre
-catalyst oxygen sensor.
Removal
Upstream oxygen sensor is mounted on exhaust pipe, in front
of catalytic converter. Raise and support vehicle. Disconnect
electrical connector for upstream oxygen sensor. Using Socket
(YA8875), remove upstream oxygen sensor from exhaust pipe.
Installation
1) If installing original or used upstream oxygen sensor,
apply anti-seize compound on threads of upstream oxygen sensor. A NEW
upstream oxygen sensor should already be coated with anti-seize
compound.
2) Install and tighten upstream oxygen sensor to
specification. See TORQUE SPECIFICATIONS. Install electrical
connector.
MOTORS, RELAYS & SOLENOIDS
IDLE AIR CONTROL (IAC) MOTOR
Removal & Installation (Dakota, Durango, Ram Pickup 3.9L,
5.2L & 5.9L, Ram Van & Ram Wagon)
1) IAC motor is located on throttle body and contains a 4-pin
electrical connector. On Ram Van and Ram Wagon, remove engine cover.
2) On all models, remove air inlet duct or air cleaner
assembly for access to IAC motor. Disconnect electrical connector at
IAC motor. Remove retaining bolts and IAC motor from throttle body.
3) To install, reverse removal procedure. Tighten IAC motor
retaining bolts to specification. See TORQUE SPECIFICATIONS.
Removal & Installation (Ram Pickup 8.0L)
1) IAC motor is located at rear of throttle body and contains
a 4-pin electrical connector. Remove air inlet duct at air cleaner
assembly. Remove cover from air cleaner assembly.
2) Remove air cleaner housing-to-throttle body nuts and air
cleaner housing from throttle body. Disconnect electrical connector at
IAC motor. Remove retaining bolts and IAC motor.
3) To install, reverse removal procedure. Tighten IAC motor
retaining bolts and air cleaner housing-to-throttle body nuts to
specification. See TORQUE SPECIFICATIONS.
A/C RELAY, AUTO SHUTDOWN (ASD) RELAY & FUEL PUMP RELAY
NOTE: A/C relay may also be referred to as A/C clutch relay or A/C
compressor clutch relay.
Removal & Installation
Relays are located in Power Distribution Center (PDC). Relays
may be identified by label on inside of PDC cover. See POWER
DISTRIBUTION CENTER (PDC) LOCATION table.