Dodge R1500 1999 Service Manual page 1614

2) Turn wiper switch off. Depress washer switch. Washer pump
and wipers should operate while switch is depressed. Wipers should
operate about 3 sweeps after switch is released. If wipers are okay
but washer is not, go to next step. If washer is okay but wipers are
not, go to step 5).
3) Turn ignition off. Disconnect negative battery cable.
Disconnect washer pump harness connector. Check resistance between
washer pump harness connector Black wire terminal and ground. If
resistance is more than zero ohms, repair open in Black wire. If
resistance is zero ohms, go to next step.
4) Connect negative battery cable. Turn ignition on. While
depressing washer switch, check voltage at washer pump harness
connector Brown wire terminal. If battery voltage exists, replace
pump. If battery voltage does not exist, repair open in Brown wire.
5) Turn ignition off. Disconnect negative battery cable.
Access CTM and disconnect CTM harness connector. Connect negative
battery cable. Turn ignition on. With washer switch depressed, check
voltage at CTM 14-pin harness connector terminal No. 10 (Brown wire).
See Fig. 3. If battery voltage exists, check intermittent relay. See
INTERMITTENT WIPER RELAY under COMPONENT TESTS. If battery voltage
does not exist, repair open in Brown wire.
Fig. 3: Identifying Central Timer Module 14-Pin Harness Connector
Terminals
Courtesy of Chrysler Corp.
WIPER