Dodge R1500 1999 Service Manual page 1592

POWER WINDOW MOTOR
NOTE: On Dakota, window motor and regulator are serviced as an
assembly.
1) Remove door trim panel. See DOOR TRIM PANEL under REMOVAL
& INSTALLATION. Disconnect window motor connector. Using jumper wires,
apply battery voltage to window motor terminals. Motor should operate,
unless window is already at maximum travel.
2) Reverse jumper wires. Window should move in opposite
direction. If window does not move in either direction, replace window
motor.
3) If motor operates in one direction only, replace motor.
See POWER WINDOW MOTOR under REMOVAL & INSTALLATION. If motor grunts
and does not move, disconnect window glass from regulator plate. Check
window glass, tracks and regulator for sticking, binding or improper
adjustment. Repair as necessary and recheck system operation.
POWER WINDOW SWITCH
1) Remove window switch from door trim panel. See POWER
WINDOW SWITCH under REMOVAL & INSTALLATION. Using an ohmmeter, check
switch continuity. See appropriate WINDOW SWITCH CONTINUITY table.
Replace power window switch as necessary. See appropriate
illustration. See Figs. 1 - 6.
2) Vehicles equipped with Auto Down feature have electronic
components in switch to actuate Auto Down. To test, check switch
continuity, reconnect switch, turn ignition on and test feature. If
Auto Down does not work, replace switch.
Fig. 1: Identifying Driver's Window Switch Terminals (Caravan,
Durango, Town & Country, & Voyager)
Courtesy of Chrysler Corp.
Fig. 2: Identifying Passenger's Window Switch & Vent Switch
Terminals (Caravan, Town & Country, & Voyager)