Dodge R1500 1999 Service Manual page 1600

door trim panel. To install, reverse removal procedure.
Removal & Installation (Dakota & Durango)
Lower window to full down position, if possible. Remove
screws attaching trim panel to door. Lift panel up and outward to
release retainers. Disconnect door handle linkage and all wiring.
remove trim panel. To install, reverse removal procedure.
Removal & Installation (Ram Pickup)
Lower window to full down position, if possible. Remove
screws attaching trim panel to door. Remove window switch. Using trim
tool, disconnect clips around edge of door. Lift panel up and outward
to release retainers. Disconnect door handle linkage and all wiring.
remove trim panel. To install, reverse removal procedure.
Removal & Installation (Ram Van & Ram Wagon)
Remove screw attaching trim panel pull cup to door. Remove
screw attaching door handle bezel to door. Remove screws attaching
trim panel to door. Using trim tool, disconnect clips around edge of
trim panel. Remove trim panel. To install, reverse removal procedure.
"D" PILLAR TRIM PANEL
Removal & Installation (Caravan, Town & Country, & Voyager -
Left Side)
1) Remove rear header trim cover. Remove liftgate sill plate.
On long wheelbase models, remove second rear seat belt turning loop.
On short wheelbase models, remove bolt securing second rear seat belt
lower anchor to quarter panel.
2) On all models, remove jack storage cover. Remove "D" panel
retaining screws. Using a trim stick, gently pry around perimeter of
"D" pillar trim panel and separate trim panel from inner quarter
panel. Disconnect rear speaker connector (if equipped).
3) On short wheelbase models, pass seat belt through slot in
"D" pillar. On all models, remove "D" pillar trim panel. To install,
reverse removal procedure.
Removal & Installation (Caravan, Town & Country, & Voyager -
Right Side)
1) Remove rear header trim cover. Remove liftgate sill plate.
On long wheelbase models, remove second rear seat belt turning loop.
On short wheelbase models, remove bolt securing second rear seat belt
lower anchor to quarter panel. Remove quarter panel trim bolster.
2) On all models, remove "D" panel retaining screws.
Disengage hidden "D" pillar trim panel clips. Separate "D" pillar trim
panel from "D" pillar. Disconnect rear speaker connector (if
equipped). Remove trim panel. To install, reverse removal procedure.
POWER WINDOW MOTOR
Removal & Installation (Caravan, Town & Country, & Voyager)
1) Disconnect negative battery cable. Remove door trim panel.
See DOOR TRIM PANEL. Remove watershield. Tape window in its existing
position. Cut and discard window motor tie wrap. Disconnect window
motor connector. Remove window motor mounting screws/nuts.
2) Remove window motor and cables from door and allow to hang
from door. Do not remove drum and cables at this time. Install NEW
window motor in door. Tighten screws/nuts to 30-40 INCH lbs. (3.4-4.5
N.m). Remove drum cover plate from faulty window motor. See Fig. 7.
Lift cable guide, drum and cables from motor.
CAUTION: DO NOT allow drum to separate from cable guide, by dropping
drum or letting cables unwind.