Dodge R1500 1999 Service Manual page 1605

removal procedure.
Removal & Installation (Ram Van & Ram Wagon)
Disconnect negative battery cable. Remove door trim panel.
See DOOR TRIM PANEL. Remove mirror flag bezel. Remove screws attaching
window switch mounting plate to mirror flag bezel. Using a thin
screwdriver, gently pry snap clips at sides of window switch
receptacle from rear of mounting plate. Pull switch out of receptacle.
To install, reverse removal procedure. Tighten mounting screws to 20
INCH lbs. (2.2 N.m).
Removal & Installation (Dakota & Ram Pickup)
Disconnect negative battery cable. Using a trim stick, gently
pry upper edge of switch bezel to release retainer securing bezel to
door trim panel. Pull switch and bezel away from door trim panel and
disconnect switch wire connector. To install, reverse removal
procedure.
Removal & Installation (Durango)
Disconnect negative battery cable. Remove door trim panel.
See DOOR TRIM PANEL. On driver's door, remove screws from back side of
door trim panel and remove switch and bezel. On passenger's doors,
gently pry snap clips at sides of window switch receptacle on back of
door trim panel switch bezel. On all doors, remove power window switch
from bezel. To install, reverse removal procedure.
WIRING DIAGRAMS