Dodge R1500 1999 Service Manual page 1602

window regulator unit. If power window motor is faulty,
entire window regulator must be replaced.
Removal & Installation (Dakota & Durango)
1) Remove door trim panel. See DOOR TRIM PANEL. Remove
watershield. Remove inner and outer belt weatherstrip. Lower glass
enough to align regulator arm-to-glass nuts with access holes in inner
door panel.
2) Remove front glass run channel. Remove nuts attaching
glass to regulator arm. Separate glass from regulator arm. Lift glass
upward and remove from door. See Fig. 8.
3) Disconnect window motor wire connector. Loosen bolts in
slotted holes attaching window regulator to inner door panel. Remove
remaining window regulator mounting bolts. Remove window regulator and
motor assembly through access hole in inner door panel. To install,
reverse removal procedure.
Fig. 8: Removing Power Window Motor (Dakota & Durango)
Courtesy of Chrysler Corp.
NOTE: On Ram Pickup, power window motor is integral to window
regulator unit. If power window motor is faulty, entire
window regulator must be replaced.
Removal & Installation (Ram Pickup)
Remove door trim panel. See DOOR TRIM PANEL. Remove
watershield. Remove nuts attaching window to regulator. Remove window
from door or tape window in raised position. Disconnect power window
motor connector. Remove regulator screws. See Fig. 9. Remove window
motor and regulator as an assembly. To install, reverse removal
procedure.