Dodge R1500 1999 Service Manual page 1504

simultaneously when throttle is depressed. If both levers to do not
move simultaneously, readjust throttle valve cable.
TRANSFER CASE SHIFT LINKAGE
Dakota
1) Place transfer case shift lever in 4L position. Use wire
or bungie cord to secure transfer case shift lever in 4L position.
Raise and support vehicle. Loosen lock bolt at adjusting swivel on
shift rod. See Fig. 8. Ensure shift rod slides freely in adjusting
swivel. If shift rod fails to slide freely in adjusting swivel,
lubricate shift rod as necessary.
2) Ensure shift lever on transfer case is still in 4L
position. Ensure pin on end of adjusting swivel is centered in hole on
shift arm. Tighten lock bolt. With all wheels off floor, start engine
and shift transfer case through all ranges to ensure proper operation.
3) Ensure pin on end of adjusting swivel is centered in hole
on shift arm. Tighten lock bolt. With all wheels off floor, start
engine and shift transfer case through all ranges to ensure proper
operation.
Fig. 8: Identifying Typical Transfer Case Shift Linkage Components
Courtesy of Chrysler Corp.
Ram Pickup
1) Place transfer case shift lever in 2H position. Use wire