Attaching The Knee Roller Pads - Precor Discovery Plate Loaded Pulldown Assembly Manual

Attaching the Knee Roller Pads

The knee roller pads on this equipment are attached to a roller bar fitted to the
center upright assembly.
To install the knee roller pads:
1. Slide the roller bar through the center upright assembly.
2. Insert one M8 x 6 set screw into each screw hole and tighten screws
completely.
Figure 8: Set screw attachment
Pulldown Assembly Guide: Assembling the Equipment
3. Slide a knee roller pad and one end cap onto the roller bar and secure it
with one M6 x 30 flat head cap screw.
Note: There is a small pin on each end of the roller bar and a small hole
next to the center hole on each end cap. The pin must extend into the hole
for the end cap to be properly positioned.
Figure 9: Knee roller attachment
4. Repeat the previous step to attach the remaining knee pad.
12