Axis Q6054 Mk III Manual page 20

AXIS Q6054 Mk III PTZ Network Camera
Specifications
Multiconnector
Terminal connector for connecting external equipment:
Audio equipment
•
Input/Output (I/O) devices
•
AC/DC power supply
•
When connecting external equipment, a separately sold Axis multicable is required in order to maintain
the product's IP rating. For more information, see .
Multicable connectors
1
Camera multiconnector
2 Audio in (pink)
3
Audio out (green)
4 Power connector, 3-pin
5
I/O terminal block, 6-pin
The multicable provides the following connectors:
Power connector -
compliant limited power source (LPS) with either a rated output power limited to ≤100 W or a rated
output current limited to ≤5 A.
DC power input
Audio in (pink) -
from a stereo signal).
Audio out (green) -
system or an active speaker with a built-in amplifier. A stereo connector must be used for the audio out.
I/O terminal connector -
motion detection, event triggering, and alarm notifications. In addition to the 0 V DC reference point and
power (DC output), the I/O connector provides the interface to:
Digital output — For connecting external devices such as relays and LEDs. Connected
•
devices can be activated by the VAPIX® Application Programming Interface or from the
product's webpage.
Digital input — For connecting external devices that can toggle between an open and
•
closed circuit, for example PIR detectors, door/window contacts, and glass break
detectors.
3-pin terminal block used for power input. Use a Safety Extra Low Voltage (SELV)
3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used
3.5 mm output for audio (line level) that can be connected to a public address (PA)
Use with external devices in combination with, for example, tampering alarms,
Multicable overview
AC power input
20