Furuno FSV85MK2 Manual page 175

Color scanning sonar

Table of Contents

Message

<<OVER TEMPERATURE!! >> RETRACT

TRANSDUCER AND TURN OFF POWER.

PRESS R/B KEY TO TURN OFF ALARM.

<<TRANSDUCER IS A HALT CONDI-

TION!!>>TD IS A HALT CONDITION. CAN'T BE

OPERATED UNTIL IT CANCELS. CHECK

STOP BUTTON IS PUSHED OR TAKE OUT

HULL UNIT RATCHET."

<<TD RECOVERED THE HALT CONDI-

TION!!>>TD RECOVERED THE HALT CONDI-

TION. PRESS  KEY, IF SAFETY IS

ENSURED. PRESS THE R/B KEY TO CLOSE

THE WINDOW.

<<TD WRONG POSITION ALARM!!>> TRANS-

DUCER IS KEPT AT WRONG POSITION. SET

BACK TRANSDUCER POSITION TO NORMAL

BY USING  KEY. PRESS R/B KEY TO TURN

OFF ALARM.

<<SHIP SPD ALARM!!>>TRANSDUCER IS

KEPT EXTENDED. MAX ALLOWABLE SPEED

FOR EXTENDED TRANSDUCER IS 18 KT.

PRESS R/B KEY TO TURN OFF ALARM.

<<SHIP SPD ALARM!!>> MAX ALLOWABLE

SPEED DURING RAISING/LOWERING

TRANSDUCER IS 15 KT. PRESS R/B KEY TO

TURN OFF ALARM.

When multiple warnings occur at the same time, the warning with the highest priority

is displayed. The order of priority is as follows:

Priority

<<TD IS A HALT CONDITION!!>>

<<TRANSDUCER NOT

RETRACTED!! >>*

<<OVERVOLTAGE!! >>

<<OVER TEMPERATURE!! (trans-

ceiver unit)>>

<<OVER TEMPERATURE!! (hull

unit, transceiver unit)>>

Message

Meaning, Remedy

This message blinks at the screen center and the

buzzer sounds when the temperature in the pow-

er supply block has exceeded 85°C;.

Press the R/B AUDIO key to silence the buzz-

er. Turn off the unit and have a qualified techni-

cian check the set.

The hull unit is stopped because the emergency

stop button in the hull unit was operated or the

ratchet wrench in the hull unit was removed.

Press the R/B AUDIO key to silence the buzz-

er. Operate the emergency stop button and/or

restore the ratchet wrench to enable raising, low-

ering operations.

The emergency stop condition at the hull unit

was released.

Silence the buzzer with the R/B AUDIO key.

This message blinks at the screen center and the

buzzer sounds when the transducer is knocked

out of position.

Try to return the transducer to its normal posi-

tion by operating the  key and silence the buzz-

er with the R/B AUDIO key.

This message blinks at the screen center and the

buzzer sounds when the transducer is extended

and ship's speed, input by external equipment,

exceeds 18 knots.

Silence the buzzer with the R/B AUDIO key

and lower ship's speed.

This message blinks at the screen center and the

buzzer sounds when the transducer is raised/

lowered and ship's speed, input by external

equipment, exceeds 15 knots.

Silence the buzzer with the R/B AUDIO key

and lower ship's speed.

Remarks