Table of Contents
Advertisement
1.2
Turning the Power On/Off
Turning the power on
Press the power switch (
sounds, and the display changes in the following sequence: FURUNO display mod-
el display board test display (see section 9.11.2). Then the lamp beside the switch
changes as below. The last-used mode is activated in approximately 140 seconds af-
ter turning the power on.
After the power is
turned on, all lamps
are lit.
Turning the power off
1. First retract the transducer with the
es while the transducer is being raised and lights steadily when it is fully raised.
Note: While raising the transducer, the ship speed must be not exceed 15 knots,
to prevent damage to the transducer and hull unit.
2. After the
blank.
If the power switch (
"Raising
make it a practice to retract the transducer before turning off the power.
1.3
Raising/Lowering the Transducer
CAUTION
CAUTION
Maximum speed while the transducer is
projected and being raised or lowered is as
below, to prevent damage to the transducer.
Transducer stopped Raising / Lowering
18 knots
). The lamp to the left of the power switch lights up. A beep
: Raise/lower keys
key lights steadily, press the power switch (
). is pressed before retracting the transducer, the message
" appears and the transducer is retracted. However, for safety purposes,
15 knots
1. OPERATIONAL OVERVIEW
After the startup tests are
complete, only the
key lamp is lit.
key. The lamp to the left of the
CAUTION
CAUTION
The transducer is stopped whenever the
emergency stop button on the hull is
operated or the ratchet (for manual raising)
is removed from its holder in the hull unit.
A message appears and the transducer cannot
be raised or lowered. Re-set the emergency
stop button or return the ratchet to its holder to
release the emergency stop condition.
key flash-
). until the screen goes
1-5
Advertisement
Table of Contents
