Table of Contents
Advertisement
2.2 Installing the Motherboard
All motherboards have standard mounting holes to fit different types of chassis. Make sure
that the locations of all the mounting holes for both the motherboard and the chassis match.
Although a chassis may have both plastic and metal mounting fasteners, metal ones are
highly recommended because they ground the motherboard to the chassis. Make sure that
the metal standoffs click in or are screwed in tightly.
Phillips Screwdriver (1)
Tools Needed
Location of Mounting Holes
Note 1. To avoid damaging the motherboard and its components, please do not use a
force greater than 8 lb/inch on each mounting screw during motherboard installation.
Note 2. Some components are very close to the mounting holes. Please take precau-
tionary measures to avoid damaging these components when installing the mother-
board to the chassis.
Phillips Screws (12)
UID_LED1
CEC_HB LED
VGA
BMC_ERR LED
PCH_ERR LED
JUSB1
COM1
USB 0/1 (3.0)
IPMI_LAN
BMC
BMC_HB_LED1
Flash
Flash
BIOS
LED6
CPLD_HB LED
JWD1
NVME1
X11DPT-BR
Rev. 1.01
Battery
BIOS
LICENSE
BAR CODE
JSD1
SXB1
CPU1
SXB2
CPU2
23
Chapter 2: Installation
Standoffs (12) (only if needed)
JSIOM1
CPU1 Slot PCI-E 3.0x16
PCH
JBT1
CMOS
Clear
SXB4
Advertisement
Table of Contents
